Table of Contents
Advertisement
Design and function
Menus and sub-menus on the machine control
5.13.3 Machine configuration menu
ENTER (enter the menu)
•
Switch off machine at the main switch
•
Press and hold the "welding parameters" button and switch the machine on again at the
same time.
NAVIGATION (navigating in the menu)
•
Parameters are selected by pressing the "welding parameters" button.
•
Set or change the parameters by turning the "welding parameter setting" rotary dial.
EXIT (leave the menu)
•
Select the "Elt" menu item.
•
Press the "welding parameters" button (settings will be applied, machine changes to the
ready-to-operate status).
62
0
1
NOTE
0
1
Figure 5-31
099-000098-EW501
03.08.2011
Advertisement
Table of Contents
