Table of Contents
Advertisement
2.4
Transport and installation
Incorrect handling of shielding gas cylinders!
Incorrect handling of shielding gas cylinders can result in serious and even fatal injury.
•
Observe the instructions from the gas manufacturer and in any relevant regulations
concerning the use of compressed air!
•
Place shielding gas cylinders in the holders provided for them and secure with fixing
devices.
•
Avoid heating the shielding gas cylinder!
Risk of accident due to improper transport of machines that may not be lifted!
Do not lift or suspend the machine! The machine can fall down and cause injuries! The
handles and brackets are suitable for transport by hand only!
•
The machine may not be lifted by crane or suspended!
Risk of tipping!
There is a risk of the machine tipping over and injuring persons or being damaged itself
during movement and set up. Tilt resistance is guaranteed up to an angle of 10°
(according to IEC 60974-1, -3, -10).
•
Set up and transport the machine on level, solid ground.
•
Secure add-on parts using suitable equipment.
Damage due to supply lines not being disconnected!
During transport, supply lines which have not been disconnected (mains supply leads,
control leads, etc.) may cause hazards such as connected equipment tipping over and
injuring persons!
•
Disconnect supply lines!
Equipment damage when not operated in an upright position!
The units are designed for operation in an upright position!
Operation in non-permissible positions can cause equipment damage.
•
Only transport and operate in an upright position!
099-000098-EW501
03.08.2011
WARNING
CAUTION
CAUTION
Safety instructions
Transport and installation
13
Advertisement
Table of Contents
