Table of Contents
Advertisement
7
Rectifying faults
All products are subject to rigorous production checks and final checks. If, despite this, something fails to
work at any time, please check the product using the following flowchart. If none of the fault rectification
procedures described leads to the correct functioning of the product, please inform your authorised
dealer.
7.1
Customer checklist
Legend
: Fault/Cause
: Remedy
The correct machine equipment for the material and process gas in use is a
fundamental requirement for perfect operation!
Functional errors
Machine control without displaying the signal lights after switching on
Phase failure > check mains connection (fuses)
No welding performance
Phase failure > check mains connection (fuses)
Various parameters cannot be set
Entry level is blocked, disable access lock (see chapter entitled "Lock welding parameters
against unauthorised access")
Connection problems
Make control lead connections and check that they are fitted correctly.
No arc ignition
Incorrect ignition type setting.
Set ignition type changeover switch to the HF ignition setting.
Bad arc ignition
Material inclusions in the tungsten electrode due to contact with filler material or workpiece
Regrind or replace the tungsten electrode
Bad current transfer on ignition
Check the setting on the "Tungsten electrode diameter/Ignition optimisation" rotary dial and
increase if necessary (higher ignition energy).
Welding torch overheated
Loose welding current connections
Tighten power connections on the torch and/or on the workpiece
Tighten contact tip/collet correctly
Overload
Check and correct welding current setting
Use a more powerful welding torch
099-000098-EW501
03.08.2011
NOTE
Rectifying faults
Customer checklist
67
Advertisement
Table of Contents
