Cisco Headset 561 And 562 With Multibase - Cisco 8851NR User Manual
Hide thumbs
Also See for 8851NR:
- Administration manual (280 pages) ,
- User manual (170 pages) ,
- Manual (44 pages)
Table of Contents
Advertisement
CISCO 8800 SERIES
Number
Name
2
Call Status LED
Cisco Headset 561 and 562 with Multibase
The Multibase can connect up to three call sources through Bluetooth, USB connector, or Y-cable. Switch
between call sources using the button interface on the Multibase. You can answer and end calls by selecting
the call control buttons on your headset, or by lifting and returning your headset to the base. The multibase
comes with the following connector cables:
• USB to USB Cable: for Cisco IP Phones with USB connectivity
• USB Y-Cable: for Cisco IP Phones without a USB port
Note
Your Cisco IP Phone administrator must enable hookswitch calling for the Y-Cable
to work.
Figure 20: Multibase LEDs
GoMomentum.com
Description
Alerts you to the call state:
• Incoming call—Blinking green.
• Active call—Steady green.
• Muted call—Steady red.
102
USER GUIDE
888.538.3690
Advertisement
Table of Contents
