Swisscom Aton CLT 615 ISDN User Manual page 85

Connecting/using other devices
Searching for Bluetooth devices
¢ ¢
v ò Bluetooth
/ Search for Data Device
The search can take up to 30 seconds.
Any incoming calls are ignored during the
search.
Cancelling/repeating current search
Cancelling the search:
§Cancel§
Press the display key.
Repeat search if necessary:
In the known devices list:
§Options§
Press the display key.
Repeat Search
Select and press
Adding the Bluetooth device to the
known devices list
Once the device has been found, its name or
address is shown on the display.
§Options§
Press the display key.
Trust Device
Select and press
~
Enter the PIN of the Bluetooth
device to be registered and
§OK§
press
¤
Generally you can enter a PIN of your
choice for a data device. Subsequently,
you must enter this PIN in the data device
too.
¤
Enter the preset PIN for the headset (usu-
ally: 0000). For further information,
please refer to the headset user guide.
The device is saved in the list of known
devices.
84
Search for Headset
§OK§
.
§OK§
.
.
Please note
u
The known devices list can only con-
tain one Bluetooth headset. If you
register a second headset, the first
one is deleted from the list.
u
If the list already contains six entries,
the last device to be entered is
deleted during the subsequent regis-
tration process. Exception: The head-
set entry is only overwritten by a new
headset and a headset only over-
writes the headset entry.
Editing the list of known (trusted)
devices
Open list
¢ ¢
v ò Bluetooth
A corresponding icon appears next to each
device name in the list displayed:
Icon Meaning
ô
Bluetooth headset
õ
Bluetooth data device
No icon is displayed for multiple service
devices.
If a device is connected, the corresponding
icon is shown in the header of the display ò
instead of .
Viewing entries
¢
s (select entry)
Open list
§View§
Press the display key.
Device name and address are displayed.
§OK§
Go back with .
Known Devices