Paper Not Supported By This Printer - Ricoh AP410 Maintenance Manual

Paper and Other Media
Additional cautions
Envelopes
Printer setup
Printer driver setup
Enabled paper feeding tray Any input tray can be used.
Both-sided printing
Additional cautions

Paper not supported by this printer

Avoid using the following paper as they are not supported by this printer.
• Paper meant for an ink-jet printer
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Paper that is dry enough to emit static electricity
• Print speed for OHP transparencies is slower than for plain pa-
per.
• Due to switching modes, the machine will be on standby for
thirty or forty seconds after the job was received.
Press [Paper Input] menu, [Paper Type], and then press [Thick Paper]
on the control panel.
❒ The paper type selected using the printer driver overrides that
selected using the control panel.
Click [Thick] in the [Type:] list.
❒ Make sure paper is not stacked higher than the upper limit
mark (T) inside the tray. Make sure paper is not stacked higher
than the paper guides inside the bypass tray.
Not possible
• Check the print side is facing up.
• Check there is no air in the envelopes before loading.
• For better print quality, we recommend the right, left, top, and
bottom print margins to be at least 20 mm (0.8") each.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten their leading edges (the edge
going into the printer) by running a pencil or ruler across them.
• Some kinds of envelope might cause misfeeds, wrinkles or
print poorly.
• Print quality on envelopes may be uneven if parts of an enve-
lope have differing thicknesses. Print one or two envelopes to
check print quality.
12