Paper and Other Media
The size is supported and indicated on the tray dial. Be sure to set the pa-
per size dial to match the actual paper size loaded in the tray.
•
The size is supported but not indicated on the tray dial. You should set the
tray dial to "p", and select the paper size with the control panel.
•
The size is supported but the paper size should be set with the control pan-
el. There is no dial on the tray.
See
p.26 "Loading Paper in the Bypass Tray"
See
p.33 "Loading Envelopes"
•
The size is supported, but it should be set as a custom size using the con-
trol panel.
The supported size may differ depending on the printer language you use.
Set as a custom size setting using the control panel.
The following sizes are supported:
• Tray 1: approximately 5.5 - 8.5 inches in width, and 5.5 - 14.02 inches
in length.
• Bypass Tray: approximately 3.54 - 8.5 inches in width, and 5.5 - 17.01
inches in length.
• Paper Feed Unit (Tray 2/3): approximately 5.5 - 8.5 inches in width, and
6.3 - 14.02 inches in length.
•
The size is not supported.
❖ Paper weight and number of sheets to be set
Tray 1
Bypass Tray
Paper Feed Unit (Tray 2, Tray 3)
Envelope Feeder Type 400
❒ Check that the top of the stack is not higher than the limit mark inside the
tray.
❒ The envelope feeder unit requires the installation of the optional paper feed
unit.
Supported paper weight
2
60 - 105 g/m
(16 - 28 lb.) 500 (80 g/m
2
52 - 162 g/m
(14 - 43 lb.) 100 (80 g/m
2
60 - 105 g/m
(16 - 28 lb.) 500 (80 g/m
See
p.33 "Loading
Envelopes".
Maximum number of
sheets (plain paper)
2
, 20 lb.)
2
, 20 lb.)
For other kind of papers,
see
p.26 "Loading Paper
in the Bypass
Tray".
2
, 20 lb.)
8