Ricoh AP410 Maintenance Manual page 76

Troubleshooting
Messages/Second
messages
Duplex Cancelled
Energy Save Mode
Error: Enter 5
or 13 characters
Error: Enter 10
or 26 characters
Exceeded Max.
Pages (Collate)
Exceeded Max.
Stored Pages
Exceeded Max.
Stored Files
Hardware Problem
DIMM
Hardware Problem
Ethernet
Description
Duplex printing specifications
canceled due to insufficient
memory or selection of a paper
size not compatible with duplex
printing.
The printer is in Energy Saver
mode.
An ID with an invalid number of
digits was entered for the WEP
key.
An ID with an invalid number of
digits was entered for the WEP
key.
The printer identified a collation
table overflow error.
The maximum number of pag-
es has been exceeded during
Sample Print or Locked Print.
The maximum number of
stored files has been exceeded
during Sample Print or Locked
Print.
An error has occurred in the
printer.
An error has occurred in the op-
tional network interface board.
Solution
Install additional memory units or re-
duce the amount of data sent.
No action required.
Enter the correct number of digits for
the WEP key.
Enter the correct number of digits for
the WEP key.
Install additional memory units or re-
duce the amount of data sent.
Reduce the number of pages to print.
Delete the stored files.
Turn the power off, and then on. If the
message appears again, call your
sales or service representative.
Turn the power off, and then on. If the
message appears again, call your
sales or service representative.
Turn off the power. Replace the net-
work interface board and turn on the
power switch.
See "Attaching Network Interface
Board Type 2610", Setup Guide.
Turn off the power, remove the net-
work interface board and turn on the
power.
❒ If you remove the network inter-
face board, you cannot print over
the network. You can send a print
jobs to the printer Only via a paral-
lel cable connection.
76