Ricoh AP410 Maintenance Manual page 18

Paper and Other Media
Changing the paper size
❒ Confirm that the setting of the paper size dial matches the paper size and feed
direction of the paper in the tray, otherwise the printer might be damaged, or
printing problems might occur.
The following explanation uses the example of "Tray 1" for the paper tray.
A
Lift the paper tray slightly, and then pull it out until it stops. Adjust the
paper size dial to match the size and feed direction of paper in the paper
tray.
❒ If you want to use the paper size and feed direction that are not indicated
on the paper size dial, set the dial to "p". In this case, you should set the
paper size using the control panel.
B
Lift the front side of the tray, and then pull it out of the printer.
C
If you load paper larger than A4K, you should extend the tray as fol-
lows:
❒ You cannot load paper smaller than A4K, if the tray is extended. In this
case, return the tray to its standard length.
18