Ricoh AP410 Maintenance Manual page 79

Troubleshooting
Messages/Second
messages
Hardware Problem
Parallel I/F
Hardware Problem
USB
Hardware Problem
Wireless Board
Hardware Problem
Wireless Card
HDD Full
HDD not Installed
Hex Dump Mode
Description
There is a problem with the par-
allel interface.
There is a problem related to
the Universal Serial Bus Con-
nection and Hardware.
An error was detected in the
IEEE 802.11b interface unit or
the Bluetooth interface unit.
The IEEE 802.11b interface
unit or the Bluetooth interface
unit could not be detected when
the power was turned on. The
IEEE 802.11b interface card or
the Bluetooth interface card
was removed after the power
was turned on. An error was
detected in the IEEE 802.11b
interface card or the Bluetooth
interface card.
The maximum HDD area size
for form/font has been exceed-
ed.
The optional Hard Disk Drive is
full. The sample print job or
locked print job to be sent from
the computer is too large to
store.
You cannot print the sample
print and the locked print jobs,
because the optional Hard Disk
Drive is not installed.
The printer is in Hex Dump
Mode.
Solution
If you use the parallel I/F, replace the
interface cable that caused the error.
If the message appears again, contact
your sales or service representative.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Turn the power off, and then on. Re-
move and re-install the IEEE 802.11b
interface unit or the Bluetooth inter-
face unit correctly.
If the message appears again, contact
your sales or service representative.
See "Attaching 802.11b Interface Unit
Type F" or "Attaching Bluetooth Inter-
face Unit Type C", Setup Guide.
Turn the power off, and then on. Re-
move and re-install the IEEE 802.11b
interface unit or the Bluetooth inter-
face unit correctly.
If the message appears again, contact
your sales or service representative.
See "Attaching 802.11b Interface Unit
Type F" or "Attaching Bluetooth Inter-
face Unit Type C", Setup Guide.
Delete the disused form/font types.
Delete any unnecessary stored files.
Install the Hard Disk Drive.
See "Attaching Hard Disk Drive Type
2600", Setup Guide.
No action required.
79