Ricoh AP410 Maintenance Manual page 78

Troubleshooting
Messages/Second
messages
Hardware Problem
IEEE1394
Hardware Problem
Option RAM
Description
The printer identified an IEEE
1394 interface board error.
The printer identified an option-
al RAM error.
Solution
Turn the power off, and then on.
Remove and re-install the IEEE 1394
interface board correctly.
A
Check the IEEE 1394 interface
board is correctly attached to the
computer.
B
Check the IEEE 1394 interface ca-
ble is securely connected.
C
Unplug the IEEE 1394 interface
cable which is connected to the
printer.
D
Restart the computer. If the mes-
sage appears even after executing
above operation, proceed to the
following steps.
E
Execute the utility tool for IEEE
1394 interface board that is stored
in the following path in the CD-
ROM labeled "Printer Drivers and
Utilities": UTILITY\ 1394
❒ For details about using the utility
tool for IEEE 1394, see the RE-
ADME file in the same directory in
the CD-ROM. If the message ap-
pears again, contact your sales or
service representative.
See "Attaching 1394 Interface Unit
Type 4510", Setup Guide.
Turn the power off, and then on. Re-
move and re-install the optional RAM.
If the message appears again, contact
your sales or service representative.
See "Attaching Memory Unit Type C
(SDRAM Module)", Setup Guide.
Turn off the power, remove the Mem-
ory Unit, and then turn on the power.
❒ If you remove the Memory Unit,
you must set up the option with the
printer driver.
❒ In this case, you might not be able
to print complex print jobs.
78