Troubleshooting; Error & Status Messages On The Control Panel - Ricoh AP410 Maintenance Manual

Troubleshooting

Error & Status Messages on the Control
Panel
This section explains what the messages that appear on the control panel mean
and what to do when a particular message appears.
❖ Messages (in alphabetical order)
Messages/Second
messages
Call Service: EC
Power Off On
/ If Error Reoccur
Call Service
Cannot check
Signal in Ad hoc
Change Setting
Tray #
/ Paper Size:
Paper Type:
Close Duplex
Unit Cover
Close
Front Cover
Close Rear/Paper
Exit Cover
Collate Cancelled
DHCP assigned
Cannot change
Driver Setting
Error (Memory)
G1128611_0.00
Description
An error A communication error
sent from the engine to the con-
troller has occurred in the print-
er.
An attempt to check the radio
signal was made while the
communication mode was set
to [802.11 Ad hoc] in the interface
settings.
The paper size and type setting
in the tray differs from that of
actual paper size and type in
the tray.
#: tray number
The cover of the optional du-
plex unit is open.
The front cover is open.
The paper exit cover or the rear
cover is open.
The collate feature has been
cancelled.
An attempt to change the IP ad-
dress, subnet mask or gateway
address was made while DHCP
was set to [On].
The printer identified a down-
load error. This error may occur
when the installed memory
amount is less than the driver
setting.
Solution
Turn the power off, and then on. If the
message appears again, call your
sales or service representative.
To check the radio signal , select In-
frastructure in the communication
mode settings.
Load paper of the selected size in the
tray, and then change the paper size
setting with the control panel. Or,
press {Form Feed}, and then select the
tray using the control panel. Or, press
{Job Reset} to cancel the print job.
You can make to setting to print disre-
garding the error message.
Close the cover of the optional duplex
unit.
Close the front cover.
Close the paper exit cover or the rear
cover.
Increase the RAM capacity.
Make the change after setting DHCP
to [Off].
Verify that the proper memory size is
specified via the driver setting.
Copyright © 2004
75