Advertisement
ASSEMBLY STEPS
STEP 1
Stud Mounting:
Find desired mounting location using a stud
finder. Hold or tape Mounting Template (E) up
to the desired mounting location using Bubble
Level (T-A) ensuring the Template is level. Mark
mounting locations that align with a stud using
a pencil. Drill 3.5" (90mm) deep pilot holes on
marked locations using a 0.25" (6mm) drill bit.
Install Mount (A) to wall using ST8x90mm Screws
(W-A), Large M8 Washers (W-C), and a 13mm
Socket Wrench.
W-A
W-C
T-A
E
A
Note:
Using 2 people is highly recommend for
installing the mount onto the wall.
Concrete/Brick:
Find desired mounting location and hold or tape
Mounting Template (E) on the wall using Bubble
Level (T-A) ensuring the template is level. Mark
mounting locations so that 4 screws are used on
the upper section of the mounting plate and 2
for the lower. Drill 3.7" (95mm) deep pilot holes
on marked locations using a 0.50" (12mm) drill
bit. Install Mount (A) to wall using Concrete
Anchors (W-B), ST8x90mm Screws (W-A), Large
M8 Washers (W-C), and a 13mm Socket Wrench.
E
A
W-C
W-A
W-B
T-A
3
Advertisement
