Maintenance And Troubleshooting - ICON Health & Fitness Pro-Form CARBON HIIT H10 User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the trainer is used. Replace
any worn parts immediately. Use only manufacturer-
supplied parts.
To clean the trainer, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFIT account or iFIT workouts, go to
support.iFIT.com.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, unplug the power adapter. Next, locate
the small reset opening (A) on the back or the side of
the console. Using a bent paper clip, press and hold
the reset button inside the opening, and have a second
person plug in the power adapter. Continue holding the
reset button until the console turns on. When the reset
operation is complete, the console will turn off and then
turn back on. If it does not, unplug and then plug in the
power adapter. Once the console turns on, check for
fi rmware updates (see HOW TO CHANGE CONSOLE
SETTINGS on page 25). Note: It may take a few
minutes for the console to be ready for use.
PEDAL TROUBLESHOOTING
If the pedals bottom out while you are exercising and
become difficult to move, rock your weight backward
and forward on the pedals until the pedals become free
and the flywheel inside the trainer begins turning again.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
Next, remove the
four indicated
M4 x 16mm Flat
Head Screws
(101) and the
Lower Rear
Shield Cover
(68).
Next, turn the Large Pulley (21) until a Pulley Magnet
(104) is aligned with the Reed Switch (116). Then,
slightly loosen the M4 x 19mm Screw (113), slide the
Reed Switch slightly closer to or away from the Pulley
Magnet, and retighten the Screw.
A
113
21 104
Then, plug in the power adapter and turn the Large
Pulley (21) for a moment. Repeat these actions, if
necessary, until the console displays correct feedback.
Then, reattach the lower rear shield cover.
28
68
101
101
116
101