Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the hybrid trainer is used.
Replace any worn parts immediately.
To clean the hybrid trainer, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries.
See assembly step 14 on page 14 for replacement
instructions.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 4 on
page 19.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, first remove the eight indicated
M4 x 20mm Screws (68).
4
68
68
68
68
Next, carefully pull the Right Shield (4) outward and
upward until you can reach the Idler Adjustment
Bolt (34).
Next, loosen the M10 Nut (70), and turn the Idler
Adjustment Bolt (34) counterclockwise until the Drive
Belt (19) is tight. Then, retighten the Nut.
See the drawing at the left. Reattach the Right Shield
(4) with the eight M4 x 20mm Screws (68).
21
4
19
34
70
Advertisement
Table of Contents
