Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Regular maintenance is important for optimal per-
formance and to reduce wear. Inspect and properly
tighten all parts each time the fitness mirror is used.
Replace any worn parts immediately. Use only manu-
facturer-supplied parts.
To clean the fitness mirror, use a damp cloth and
a small amount of mild soap or glass cleaner.
IMPORTANT: To avoid damage to the fitness mirror,
keep liquids away from the fitness mirror and keep
the fitness mirror out of direct sunlight.
TABLET TROUBLESHOOTING
If the tablet does not turn on, make sure that the power
adapter is fully plugged in and that the power switch is
pressed on.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the tablet, use
only a manufacturer-supplied regulated power
adapter.
For the best results, regularly check for firmware
updates (see HOW TO CHANGE TABLET SETTINGS
on page 17).
If you are having problems connecting the tablet to
a wireless network, or if you are having problems
with your iFit account or iFit workouts, go to
support.iFit.com.
If the tablet does not boot up properly, or if the tablet
freezes and does not respond, reset the tablet to the
factory default settings. IMPORTANT: Doing this will
erase all custom settings
you have made to the
tablet. Resetting the tablet
requires two people. First,
press the power switch and
unplug the power adapter.
Next, locate the small reset opening (A) on the back
of the tablet. Using a bent paper clip, press and hold
the reset button inside the opening, and have a sec-
ond person plug in the power adapter and press the
power switch. Continue holding the reset button until
the tablet turns on. When the reset operation is com-
plete, the tablet will turn off and then turn back on. If
it does not, unplug the power adapter and then plug it
in again. Once the tablet turns on, check for firmware
updates (see HOW TO CHANGE TABLET SETTINGS
on page 17). Note: It may take a few moments for
the tablet to be ready for use.
HOW TO ADJUST THE DOOR AND THE HINGE
If the door does not move easily, or if the door moves
too freely, the upper bracket on the hinge needs to be
adjusted.
See the EXPLODED DRAWING on page 23.
Locate the Upper Bracket (15) on the Hinge (7).
Loosen or tighten the M8 x 15mm Screw (31) in the
Upper Bracket until the Door (3) moves as desired.
If the hinge does not move easily, or if the hinge
moves too freely, the lower bracket in the cabinet
needs to be adjusted.
See the EXPLODED DRAWING on page 23.
Locate the M8 x 15mm Screw (31) in the bracket in
lower right side of the Cabinet (1). Loosen or tighten
the Screw until the Hinge (7) moves as desired.
20
A
Advertisement
Table of Contents
