Maintenance And Troubleshooting - ICON Health & Fitness HEALTHRIDER H70e User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the elliptical
exerciser regularly. Replace any worn parts immedi-
ately.
CONSOLE TROUBLESHOOTING
If the console displays become dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 7 on page 9
for replacement instructions. If the handgrip pulse sen-
sor does not function properly, see step 5 on page 13.
HOW TO REMOVE THE SHIELDS AND THE
FLYWHEEL COVERS
The Left and Right Shields (15, 16) must be removed
before the reed switch or the drive belt can be
adjusted. To remove the Shields, remove the indicated
Screws (71, 72). Note which hole each Screw is
removed from; the Screws must be reattached in
the same holes. Carefully separate and remove the
Shields.
71
15
72
Next, the Right
and Left
Flywheel Covers
(18, 19) must be
removed.
48
Remove the indi-
cated Screws
(48, 69) from the
Flywheel Covers.
69
Note which
hole each
Screw is
removed from;
the Screws must be reattached in the same holes.
Carefully separate and remove the Flywheel Covers.
All manuals and user guides at all-guides.com
16
71
72
48
18
19
69
69
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first see the instructions at the left and remove
the shields and the flywheel covers.
Next, see the drawing below. Locate the Reed Switch
(55). Turn the Pulley (38) until a Magnet (37) is
aligned with the Reed Switch. Loosen, but do not
remove, the indicated Screw (72). Slide the Reed
Switch slightly closer to or away from the Magnet, and
then retighten the Screw. Turn the Pulley for a
moment. Repeat these actions until the console dis-
plays correct feedback. Then, reattach the shields and
the flywheel covers.
72
37
38
55
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
setting, the drive belt may need to be adjusted. To
adjust the drive belt, first see the instructions at the
left and remove the shields and the flywheel covers.
39
76
74
Next, see the drawing above. Loosen the indicated
Jam Nut (76). Tighten the indicated Screw (74) until
the Drive Belt (39) is properly tightened, and then
retighten the Jam Nut (76). Then, reattach the shields
and the flywheel covers.
17