ICON Health & Fitness Pro-Form CARBON HIIT H10 User Manual page 11

8. Identify the Right and Left Handlebars (10, 11).
Make sure that the Pedals (22, 23) are level.
Attach the Right Handlebar (10) to the Right
Handlebar Arm (15) with three M8 x 25mm
Screws (105); start all the Screws, and then
tighten them. Tip: It may be helpful to rotate
the Right Handlebar for better access to
tighten the Screws.
Attach the Left Handlebar (11) in the same
way.
9. Identify the Rear and Front Pivot Covers
(65, 66).
Press a set of Rear and Front Pivot Covers
(65, 66) together around the Right Handlebar
(10) near the bend (B). Then, attach them to
each other with two M4 x 22mm Screws (107).
See the inset drawing. Slide the Rear and Front
Pivot Covers (65, 66) toward the Shield Cover
(12). Attach the Front Pivot Cover to the Right
Handlebar (10) with an M4 x 22mm Screw (107).
Repeat this step on the other side of the
trainer.
8
11
22, 23
9
65
65
10
66
107
11
10
15
105
10
66
107
B
12