Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the fitness mirror is used.
Replace any worn parts immediately.
To clean the fitness mirror, use a damp cloth and
a small amount of mild soap or glass cleaner.
IMPORTANT: To avoid damage to the fitness mirror,
keep liquids away from the fitness mirror and keep
the fitness mirror out of direct sunlight.
TABLET TROUBLESHOOTING
If the tablet does not turn on, make sure that the power
adapter is fully plugged in and that the power switch
is pressed on. If a replacement power adapter is
needed, call the telephone number on the cover of
this manual. IMPORTANT: To avoid damaging the
tablet, use only a manufacturer-supplied regulated
power adapter.
For the best results, regularly check for firmware
updates (see HOW TO CHANGE TABLET SETTINGS
on page 11).
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate this equipment.
IMPORTANT: To satisfy exposure compliance requirements, the antenna and transmitter in the tablet
must be at least 8 in. (20 cm) from all persons and must not be near or connected to any other antenna or
transmitter.
Note: The tablet contains FCC ID: OMC420612.
If you are having problems connecting the tablet to
a wireless network or if you are having problems
with your iFit account or iFit workouts, go to
support.iFit.com.
If the tablet does not boot
up properly, or if the tab-
let freezes and does not
respond, reset the tablet to
the factory default settings.
IMPORTANT: Doing this
will erase all custom settings you have made to
the tablet. Resetting the tablet requires two people.
First, press the power switch and unplug the power
adapter. Next, locate the small reset opening (A) on
the back of the tablet. Using a bent paper clip, press
and hold the reset button inside the opening, and have
a second person plug in the power adapter and press
the power switch. Continue holding the reset button
until the tablet turns on. When the reset operation is
complete, the tablet will turn off and then turn back on.
If it does not, unplug the power adapter and then plug
it in again. Once the tablet turns on, check for fi rmware
updates (see HOW TO CHANGE TABLET SETTINGS
on page 11). Note: It may take a few moments for
the tablet to be ready for use.
14
A
Advertisement
Table of Contents
