Adding A Service To A Destination Device; Removing A Service; Changing Parameters For A Service - GE LOGIQ S8 Service Manual

GE H RAFT
EALTHCARE
D 5394227, R
IRECTION EVISION
3.) Service Parameters - lists parameters for the service currently selected in the Services section. The
name and parameters in this section change, depending on what service is currently selected. In
the above figure, this section shows DICOM Print parameters.
3-12-6-1

Adding a service to a destination device

1.) Select the service from the pull-down menu. Press Add.
2.) Specify the properties for this service. Press Save.
3.) Verify the service.
3-12-6-2

Removing a service

1.) Select the service. Press Remove.
2.) Press Save.
3-12-6-3

Changing parameters for a service

There are certain parameters that may need to be set up for each service:
Table 3-24
Preset Parameter
Name
AE Title
Port Number
Maximum Retries
Retry Interval (sec)
Timeout
Many service parameters are specific to each type of service. The parameters are described on the
following pages:
• DICOM Image Storage
• DICOM Performed Procedure
• DICOM Print
• DICOM Query/Retrieve
• DICOM Storage Commitment
• DICOM Worklist
• Standard Print
• Video Capture
• Save As
• Network storage
3-48
3 DRAFT (N
Service Parameters: Common Service Parameters
Free text: give a descriptive name to the device.
The Application Entity Title for the service.
The port number of the service.
Max # - the maximum number of times to try establishing a connection to the service.
Specify how often (in seconds) the system should try to establish a connection to the service.
The amount of time after which the system will stop trying to establish a connection to the
service.
Section 3-12 - Configuring Connectivity
17, 2011)
OVEMBER
Description
LOGIQ™ S8
S M
ERVICE ANUAL