Fcc Compliance Statement - Epson EX11000 Service Manual

No. Symbol
28
29
30
Parent topic:

FCC Compliance Statement

For United States Users
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause interference to radio and television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Approved Standards
—
ISO7010
No. W027
ISO3864
IEC60417
No. 5109
Notices
Description
Never look into the projection lens while
the projector is on.
Warning, light emission (UV, visible light,
IR and so on)
To indicate that you must be careful not
to injure your eyes or skin when near light
emitting sections.
Not to be used in residential areas
To indicate that the electrical
equipment/device is not suitable for use
in residential area.
301