Solutions To Remote Control Problems - Epson EX11000 Service Manual

• If the projector's laser shuts off unexpectedly, it may have entered standby mode after a period of
inactivity. Press the power button to wake the projector and adjust the Sleep Mode setting to change
the sleep interval.
• If the projector's light source turns off unexpectedly, the A/V mute timer may be enabled. Select Off as
the A/V Mute Timer setting.
• If the projector's light source shuts off, the status light is flashing blue, and the temp light is orange, the
projector has overheated and shut off. Check the solutions for this light status.
• Make sure the A/V Mute Timer setting and the Lens Cover Timer setting are turned off in the
Operation menu.
• If the power button on the remote control does not turn on the projector, check its batteries and make
sure the Remote Receiver setting is turned on in the projector's menu, if available.
• The power cord may be defective. Try another power cord. If that doesn't work, disconnect the cord
and contact Epson.
• The cooling fans may run in standby status depending on the projector settings. Also, when the
projector wakes from standby status, the fans may cause an unexpected noise. This is not a
malfunction.
Parent topic:
Related references
Where to Get Help (U.S. and Canada)
Projector Light Status
Feature Settings - Operation Menu
Related tasks
Unlocking the Projector's Buttons

Solutions to Remote Control Problems

If the projector does not respond to remote control commands, try the following solutions:
• Check that the remote control batteries are installed correctly and have power. If necessary, replace
the batteries.
• Make sure you are operating the remote control within the reception angle and range of the projector.
• Make sure the projector is not warming up or shutting down.
• Check to see if a button on the remote control is stuck down, causing it to enter sleep mode. Release
the button to wake the remote control up.
Solving Projector or Remote Control Operation Problems
275