Solutions To Password Problems - Epson EX11000 Service Manual

• Strong fluorescent lighting, direct sunlight, or infrared device signals may be interfering with the
projector's remote receivers. Dim the lights or move the projector away from the sun or interfering
equipment.
• If available, turn on one of the remote receivers in the projector's menu system, or check if all the
remote receivers were turned off.
• If the remote receiver setting is off, press and hold the Menu button on the remote for at least 15
seconds to restore the default setting.
• If you assigned an ID number to the remote control to operate multiple projectors, you may need to
check or change the ID setting.
• To set the remote control so it will operate any projector, hold down the ID button and press the 0/All
button.
• If you lose the remote control, you can purchase another from an Epson parts distributor.
Parent topic:
Related references
Remote Control Operation
Related tasks
Installing Batteries in the Remote Control
Replacing the Remote Control Batteries

Solutions to Password Problems

If you cannot enter or remember a password, try the following solutions:
• If you lose the remote control, you cannot enter a password. Order a new one from an Epson parts
distributor.
• If you have entered an incorrect password too many times and see a message displaying a request
code, write down the code and contact Epson. Do not attempt to enter the password again. Provide
the request code and proof of ownership for assistance in unlocking the projector.
Note: If you perform Reset All or Reset Network Settings in the projector's menu, all of the
passwords that have been set for the Network menu are also reset and you need to set them again.
To prevent the passwords from being reset by unauthorized users, set Network to On in the Menu
Protection menu.
Parent topic:
Solving Projector or Remote Control Operation Problems
Solving Projector or Remote Control Operation Problems
276