Siemens SIMATIC IPC427E Operating Instructions Manual page 69

Installation
1. Place the HDD/SSD onto the base plate.
Observe the recess position shown when
installing an SDD. The SSD interfaces
should be located opposite the recess.
2. Insert the new HDD/SSD into the enclo-
sure.
Take care that the nameplate is on top.
Slide the HDD/SSD into the enclosure until
you can see the mounting holes.
3. Turn in the marked screws.
4. Insert the cover into the enclosure.
Turn in the marked screws.
SIMATIC IPC427E
Operating Instructions, 02/2021, A5E37454814-AE
Device maintenance and repair
7.3 Installing and removing hardware
69