Table of Contents
Advertisement
Chapter 4: UEFI BIOS
When SEL is Full
This feature allows you to decide what the BIOS should do when the system event log is full.
Select Erase Immediately to erase all events in the log when the system event log is full. The
options are Do Nothing and Erase Immediately.
Note: All values changed here do not take effect until computer is restarted.
BMC Network Configuration
BMC Network Configuration
Update IPMI LAN Configuration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If the feature above is set to Yes, Configuration Address Source, VLAN, and IPv6
Support are available for configuration:
Configure IPv4 Support
IPMI LAN Selection
IPMI Network Link Status
Configuration Address Source
This feature allows you to select the source of the IP address for this computer. If Static is
selected, you need to know the IP address of this computer and enter it to the system manually
in the field. If DHCP is selected, the BIOS searches for a Dynamic Host Configuration Protocol
(DHCP) server in the network that is attached to and request the next available IP address
for this computer. The options are DHCP and Static.
*If the feature above is set to Static, the following features are available for configuration:
Station IP Address
This feature displays the Station IP address for this computer. The address can be manually
entered. This should be in decimal and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This feature displays the sub-network that this computer belongs to. The address can be
manually entered. The value of each three-digit number separated by dots should not exceed
255.
Station MAC Address
95
Advertisement
Table of Contents
