Supermicro X12SDV-4C-SPT4F User Manual page 75

SATA SGPIO/LED
Use this feature to select between SATA SGPIO or SATA LED. The options are SGPIO and
SATA LED.
SATA Port 0–3
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Software Preserve Support
SATA Port 0–3 Hot Plug
Set this feature to Enable for hot plug support, which allows you to replace a SATA drive
without shutting down the system. The options are Disabled and Enabled.
SATA Port 0–3 Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are
Disabled and Enabled.
SATA Port 0–3 SATA Device Type
Use this feature to specify if the SATA port specified should be connected to a Solid State
Drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCH SATA1 Configuration

PCH SATA1 Configuration
SATA Controller 1
This feature enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are Enabled and Disable.
SATA Mode Selection
Select AHCI to configure an sSATA drive specified as an AHCI drive. Select RAID to configure
an sSATA drive specified as a RAID drive. The options are AHCI and RAID.
Support Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power usage of
the SATA link. The controller puts the link in a low power mode during extended periods of I/O
inactivity and then returns the link to an active state when I/O activity resumes. The options
are Disabled and Enabled.
SATA Port 0
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Software Preserve Support
75
Chapter 4: UEFI BIOS