Table of Contents
Advertisement
EMI Receiver Instructions for Use
(2) Standard curve marking and viewing:
[Stop scanning]→[FREQ][Receive frequency change (check mark)][Start scanning]
(3) Limit line editing: You can edit the measurement standard limit line by yourself
[Meas Setup][New/Edit]Name]Value[Add/Insert]Save
(4) Compensation setting: You can input antenna coefficient, near-field probe calibration coefficient, LISN insertion loss, etc.
[Mode]→[EMI]→[Meas]→[Compensation]
2.2 Network measurement
introduce:
Network measurement is a port measurement, using the signal source and receiving source inside the instrument to complete the port connection test,
Specifically, it can directly test the filter, the insertion loss value of the cable, the magnification of the amplifier, etc.
Enter the operation interface:
[Mode]→[Network Measurement]→[FREQ]→[Output Power]→[Scan Points]
Use the output terminal RF OUT 50[ input and RF OUT 50] terminals to make a test. See 3.3 for detailed operation
section introduction.
3. EMI Receiver Measurements
3.1 Measurement items under EMI state
3.1.1 Main functions
1. Able to use the instrument to check military standards (GJB151A, GJB151B), national standards (GB17743, GB9254, GB4824),
22
Advertisement
Table of Contents
