EMI Receiver Instructions for Use
2.2.3.3 Fast scan/measurement
EMI receiver quick measurement is divided into single-segment measurement and multi-segment measurement.
Single-segment measurement: scan with the parameters currently set by the receiver. The scanning step is automatic according to the IF bandwidth
The start and end frequency can be set by [FREQ] menu; the resolution bandwidth can be set by [BW]
Certainly.
Operation steps, first [Sweep] → [Current Settings] → [Start Scanning], and then set other
Related parameters, such as frequency [FREQ], amplitude [AMPT], bandwidth [BW], measurement time [Meas],
Trace [Trace], detector [Detector].
ÿ Multi-segment measurement: The receiver mode has built-in 10 interval measurements with adjustable steps, and each interval can be carried out
Measurement of different parameters
Interval parameters can be set independently, up to 10 intervals can be set, after the setting is completed, click 【Sweep】→
【Column】
Table scan] → [Start scan] to complete multi-segment scan.
Default interval 1 parameter
Zone 1
1KHz
Scan start
300MHz
Scan termination
Zone 2
Zone 3
20
Zone 4
Zone 5