Saluki SER Series User Manual page 13

EMI Receiver Instructions for Use
【FREQ】
Frequency parameter setting
【SPAN】
Span setting
【AMPT】
Amplitude setting
【AUTO】
Auto Search
【BW】
Resolution Bandwidth Set
【Sweep】
Scanning Time Set
【Trig】
Trigger mode setting
【Trace】
Trace settings
【Detector】
【Display】
Analyzer Setup Keypad
Detection mode
Display settings
center frequency, start frequency, stop frequency, frequency step (from
manual/manual), frequency offset (default 0Hz), frequency reference (internal
internal/external), LF channel (on/off)
Span (automatic/manual), full span, zero span, previous span
Reference level, attenuator, scale/div (default 10dB), scale
Type (Linear/Logarithmic), Reference Bias (0dB),
Reference units (dBm, dBuV, dBpW, dBmW, dBmV, W,
V), pre-amplification (automatic/manual)
Automatically test RF IN 50ÿ input RF signal
resolution bandwidth (auto/manual), resolution step (default/continuous
continued), video bandwidth (on/off)
the scanning time (automatic/manual), single scanning,
continuous scanning,
Scan point settings
automatic, video (-20.00dB), external (rising edge/falling edge)
Trace (1, 2, 3), Refresh, Max Hold, Min Hold,
Blanking, viewing, trace calculation
setting automatic, normal, positive peak, negative peak, sampling
Full screen display, window scaling (on/off), display lines
-25dBm (on/off), grid (on/off), amplitude
Ruler (on/off), label (on/off)
12