Table of Contents
Advertisement
Bead Setup Screen
F
. 24 Bead Setup Screen
IG
On the Bead Setup Screen, press 'F1' or select
display the System Main Screen. Press 'F7' or select
to return to the previous screen. Press 'F8' or
select
to continue to the next screen.
The content and functions of this screen are as follows:
•
Select to set dispense rate. If '0' is set, the system
skips the program number and execute the
following.
•
The 'Prog.No' is the preset program number of
'Prog.select' for bead mode in automatic operation.
See Working mode, page 21 for more details.
•
The system supports 16 groups of setting.
Sequence Setup Screen
F
. 25 Depressurization Setup Screen
IG
On the Depressurization Setup Screen, press 'F1' or
to
select
to display the System Main Screen. Press
'F7' or select
Press 'F8' or select
The system displays sequence setup screen when
sequence mode is enabled. To enable sequence mode,
see Enable sequence mode, page 32.
Sequence includes 16 steps maximum. Step 0 and step
15 are used to start job (Pre-charge) and end job
(Depressurization). Operator can select functions
including shot, bead, reload and not used. If the shot or
bead function is selected, repeat time can be set (1-99).
HMI Display Operation and Identification
to return to the previous screen.
to continue to the next screen.
29
Advertisement
Table of Contents
