Important Considerations For Wireless Settings; Point-To-Point And Point-To-Multipoint Considerations - Cisco FM3200 Base Installation And Configuration Manual

operating in the same area. The frequencies shown on the
Frequency (MHz) selector are the carrier frequencies.
• Operation in the 4.9 GHz band must be enabled using a
Cisco
management" (page 131)
band is not available in Brazil and Canada.
5. If Advanced configuration mode was selected, choose the
required channel bandwidth from the Channel Width (MHz)
drop-down. Note that the radio units on both sides of a wireless
link must be set to the same channel width value. A channel
width mismatch will result in degraded communication between
the units.

Important considerations for wireless settings

The following sub-sections contain important technical and regulatory
information that
RADIO window.
• For information on the effects of network topology on frequency
selection,
considerations" (page
• For information on how to avoid network co-location interference,
refer to "Co-location considerations" (page
• For information on the effects of channel width on data rate and
throughput, refer to
• For information on using dynamic frequency selection to avoid
interference with terminal doppler weather radar, refer to
frequency selection considerations" (page

Point-to-Point and Point-to-Multipoint considerations

If a Cisco radio transceiver unit's FluidMAX Autoscan setting is
enabled, and the unit is assigned a Subordinate role within a point-to-
multipoint network topology:
• The Subordinate unit will mimic the frequency setting of the
primary unit that shares its cluster ID.
• The Subordinate unit's manual frequency selection setting will be
disabled by default.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
software plug-in.
for details. Note that the 4.9 GHz
CAUTION
Before finalizing the settings on the WIRELESS
RADIO window, refer to
for wireless settings" (page 61)
contains important information that may influence
your choice of wireless settings.
influences the settings
refer to "Point-to-Point
61).
"Channel width considerations" (page
Refer to "Plug-In
"Important considerations
below. This section
on the WIRELESS
and Point-to-Multipoint
62).
62).
"Dynamic
63).
Page 61 of 176