Changing Filament - Flashforge Adventurer 4 Quick Start Manual

Changing filament

1. Press Prepare
5. Open the hatch.
8. Press Next and then Next again. The filament feeds automatically.
9. Press Complete when you see filament coming out of the extruder.
If the extruder becomes clogged. See cleaning instructions on the supplied
USB stick.
2. Press Filament 3. Press Change 4. The extruder will
6. Remove the current
filament reel and pull
the rest of the filament
from over the feed
wheel.
10
heat up. Once
the extruder
has heated up,
the filament will
automatically be
feed out.
7. Fit the new filament
and pass it over
the feed wheel.