Flashforge Adventurer 4 Quick Start Manual page 9

Printing
1. Connect a USB stick.
2. Press Build and select USB Device.
3. Select the relevant file in the list
and press Build to start printing.
The extruder heats up and printing
starts when the heating is complete.
When printing is complete, the
printer beeps and a message
appears on the display.
4. Take out the finished model.
Warning: The build plate and
the exruder may be very hot when
printing is complete. Allow the parts
to cool before removing the model.
5. Lightly lift the build plate and remove
it from the platform base.
6. Carefully flex the build plate to
release the model. You might need
to use a spatula if the model is
very big or small.
9