Loading / Changing Filament - Flashforge FINDER Quick Start Manual

Build Preheat
1. Tap [Tools] and then tap [Filament] and [Load] to load filament.
Load Unload
2. The extruder will automatically heat up. Once heated, filament will be drawn through the
extruder. Continue extruding until the extruder provides a steady flow of filament.
Changing Filament
Build Preheat
1. Tap [Preheat]--[Start] to heat up the extruder.
2. Once preheated, hold down the spring presser and pull out the filament.
3. Tap the return arrow, then insert the new filament into the filament intake. Select [Tools]-
[Filament]-[Load]. The filament will be drawn through the extruder once heated. Wait for the
extruder to provide a steady flow of filament.

Loading / Changing Filament

Tools
Do not pull out the filament with force as it will damage the gears. If the melted
filament has cooled down in the extruder, please follow the steps below.
Tools
Filament Level
Setting Status
I'm heating up...
Extruder
Extruder
08
HOME
Home Manual
About
100%
220℃ / 220℃
Cancel
220℃
Start