Loading / Changing Filament - Flashforge Inventor II Quick Start Manual

Build Preheat
1. Tap [Tools] and then tap [Filament].
Load
2. Tap [Load]. The extruder will automatically heat up. Once heated, filament will be drawn
through the extruder. Continue extruding until the extruder provides a steady flow of filament.
Changing Filament
Build Preheat
1. Tap [Preheat]--[Start] to the heat up the extruder.
2. Once preheated, hold down the spring presser and pull out the filament.
3. Tap the return button, insert the new filament into the filament intake, tap [Tools]-[Filament]-
[Load]. The filament will be drawn through the extruder once heated. Wait for the extruder to
provide a steady flow of filament.

Loading / Changing Filament

Tools
Unload
Do not pull out the filament with force as it will damage the gears. If the melted
filament has cooled down in the extruder, repeat the following steps below.
Tools
Filament Level
Setting Status
I'm heating up...
Extruder
Extruder
08
HOME
Home Manual
About
27%
100%
61℃ / 220℃
220℃
Start