Flexpower With Integrated Battery; Flexpower ® Solar Supply; Battery Life Calculations; Analog Configuration - Banner Sure Cross Performance DX80 Instruction Manual

Voltage
0 Volts

8.2.2 FlexPower with Integrated Battery

Some FlexPower devices operate using a battery integrated into the housing.
These devices powered by integrated batteries:
• Operate only from the battery and cannot use an external power supply, and
• Are limited in the available I/O because of the limited connectivity.
®
8.2.3 FlexPower
Banner's FlexPower Solar Supply Assembly can supply power to two radio devices, including a FlexPower Node, a
FlexPower Gateway, or a data radio.
When used with a FlexPower Node and sensors, the FlexPower Solar
Assembly supplies enough power to run most sensors at higher
sample and report rates than a single battery can reasonably
support.
The solar panel recharges the battery pack that powers the devices.

8.3 Battery Life Calculations

8.3.1 Analog Configuration

The battery life calculations, in years, for some analog sensors are shown in the table below.
Table 1: Battery Life in Years
Manufacturer
1 Banner
2 Esterlink/KPSI
3 Turck
All manuals and user guides at all-guides.com
Warmup Time
Sample point
Figure 3. Switch Power
Solar Supply
Device
U-Sonic/Distance
Submersible Level
Pressure
www.bannerengineering.com - Tel: 763.544.3164
®
Sure Cross Performance DX80 Wireless I/O Networks
Switch Power
Sample interval
Figure 4. FlexPower Solar Assembly
Model
QT50ULBQ6-75390
KPSI Series 700
PT100R-11-L13-H1131
Sample point
Boost Voltage Warmup Time
15 V 500 ms
10 V 10 ms
10 V 10 ms
65