Correction Procedures; Rebooting The Software; Restoring Factory Settings - ABB RELION REC615 Operation Manual

Section 7
Troubleshooting
7.3
7.3.1
7.3.2
110
Warning indication
Warning
AFL error
Warning
SMV config error
Warning
Comm. channel down
Warning
Unack card comp.
Warning
Protection comm.
Warning
ARC1 cont. light
Warning
ARC2 cont. light
Warning
ARC3 cont. light
Warning
RTD card error,X130
Warning
RTD meas. error,X130

Correction procedures

Rebooting the software

1.
Select Main menu/Configuration/General/Software reset and press
2.
Change the value with

Restoring factory settings

In case of configuration data loss or any other file system error that prevents the
protection relay from working properly, the whole file system can be restored to the
original factory state. All default settings and configuration files stored in the factory
are restored. Only the administrator can restore the factory settings.
1.
Select Main menu/Configuration/General/Factory setting and press
2.
Set the value with
3.
Confirm by selecting Yes with
The protection relay restores the factory settings and restarts. Restoring takes 1...3
minutes. Confirmation of restoring the factory settings is shown on the display a few
seconds, after which the relay restarts.
Warning code Additional information
33 Analog channel configuration error.
34 Error in the SMV configuration.
35 Redundant Ethernet (HSR/PRP)
communication interrupted.
40 A new composition has not been
acknowledged/accepted.
50 Error in protection communication.
85 A continuous light has been detected on
the ARC light input 1.
86 A continuous light has been detected on
the ARC light input 2.
87 A continuous light has been detected on
the ARC light input 3.
96 Temporary error occurred in RTD card
located in slot X130.
106 Measurement error in RTD card located in
slot X130.
or and press
or and press
or and press
1MRS758754 B
.
.
.
REC615 and RER615
Operation Manual
.
.