Table of Contents
Advertisement
Delayed Egress
ED4000, ED5000 Series Exit Device
Installation Instructions
Wiring Layout: Input/Output Wiring Descriptions, continued
6
J2 Connector (See Figure 5 below.)
Pin Number
NC
NC
NC
2
NOTE: ElectroLynx QC12 Hinge is required if DPS and/or any options shown are required.
NOTE: Refer to Section 25 if replacing legacy PCBA/wiring with new PCBA/wiring.
7
ElectroLynx Connector System for All Electrical Installation
1. Mount exit device per instruction sheet provided.
2. Plug exit device connector into raceway connector in door. Feed through 1" (25mm) hole in door.
Install rail mounting end clamp bracket with two (2) screws supplied. Install end cap.
3. Plug raceway connector from edge of door into electric hinge connector and feed wires back
through door prep. Mount electric hinge to door.
A. If wiring now, wire frame side wires, to wires on pigtail harness, on hinge as required by using
connectors allowed by local code. Plug pigtail harness connector into electric hinge connector.
Feed harness through frame prep and mount electric hinge.
B. If wiring later, plug pigtail harness connector into electric hinge connector. Feed harness through
frame prep and mount electric hinge.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2006, 2010, 2018, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Wire
Input/Output
Color
Input/Output
Violet
Input/Output
Gray
Input/Output
Pink
Input
Tan
Description
C, LBM or C, Trim Mon. or ET(-)
NO, LBM or NO, Trim Mon. or ET(+)
NC, LBM or NC, Trim Mon.
Door Position Switch Input-Input sense for DPS
switch option
10
4-Pin ElectroLynx Connector
Pin Number
1
2
3
4
Top View
Bottom
View
Figure 5
FM209 10/20
Hide quick links:
Advertisement
Table of Contents
