Hood Lock (Solenoid) - HP Z1 Entry Tower G5 Maintenance And Service Manual

Hood lock (solenoid)

The hood lock is secured to the rear of the chassis with two screws.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the cable (1) from the system board connector labeled HLCK.
4. Remove the two screws (2) that secure the lock to the rear of chassis.
5. Lift the hood lock out of the chassis (3).
To install the hood lock, reverse the removal procedure.
52 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page 18).
17).