Hood Lock - HP EliteDesk 800 G5 SFF Maintenance And Service Manual

Hood lock

The hood lock is secured to the back of the computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the cable from the system board connector labeled HLCK (1), and then remove the cable
from the clip on the fan duct (2).
4. Remove the screw that secures the hood lock to the rear of the computer (3), and then remove the hood
lock from the inside of the computer (4).
To install the hood lock, reverse the removal procedure.
48 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page 19).
18).