Table of Contents
Advertisement
WARNING! If any part is missing or damaged, do not plug the drill press in until the missing or damaged
part is repaired or replaced.
ASSEMBLY
1. Position the base on the floor. Attach the column to the base
using four M10x30 hex head bolts (Fig. 2).
2. Loosen the set screw (Fig. 3 - 1) and remove the column
collar (Fig. 3 - 2) and gear rack (Fig. 3 - 3) from the column.
With the help of a friend, place the rack inside the table bracket
before sliding the table assembly (Fig. 3 - 4) with the rack down
onto the column. Place the column collar down over the rack
after positioning the rack and the table in place. Tighten the col-
lar's set screw with a hex wrench to hold the rack into position.
3. Install the table adjustment crank (Fig. 4 - 1). Secure it in
place by tightening the set screw (Fig. 4 - 2). This handle will
control the height of the drill press table.
4. Screw the table locking handle into position (Fig. 5 - 1).
Tightening this handle prevents the table from swivelling and
having its height adjusted.
5. Install the head assembly with the help of a friend by care-
fully lifting the head above the column. Slide it onto the column,
making sure the neck goes down as far as possible (Fig. 6).
6. Align the head with the base so they are parallel with one
another and facing the same direction. Tighten the set screw
(Fig. 7 - 1).
7. Install the feed handles (Fig. 8 - 1) into place using three
M8x12mm socket head screws (Fig. 8 - 2).
Fig. 6
ASSEMBLY & ADJUSTMENTS
Fig. 7
1
Fig. 2
1
2
1
Fig. 3
2
4
3
Fig. 4
1
Fig. 5
Fig. 8
1
2
11
Advertisement
Table of Contents
