Assembly & Adjustments - Wen 23101 Instruction Manual

WARNING! To avoid injury from accidental startups, always ensure that the tool is switched OFF and un-
plugged from the power supply before making adjustments or changing accessories.
INSTALLING ROTARY TOOL BITS
1. Switch off and unplug the tool before attempting any adjustments.
2. Hold down the spindle lock button (Fig. 1 - 1) and rotate the collet
nut (Fig. 1 - 2) until the lock engages.
3. Using the included wrench, loosen the collet nut (Fig. 1 - 2) by turn-
ing it counterclockwise and remove. Release the spindle lock button.
4. The collet is located inside the collet nut. Your rotary tool is pre-
installed with a 1/8" collet and includes a 3/32" collet as an accessory.
Select the suitable collet to match the spindle diameter of your rotary
tool bit. Insert the selected collet into the spindle hole and screw the
collet nut back on, but do not tighten it all the way.
5. Fully insert the rotary bit into the center hole through the collet nut and collet. Press down the spindle lock but-
ton and fully tighten the collet nut using the included wrench. Check to ensure that the rotary bit is firmly secured
inside the tool.
INSTALLING SANDING DISCS AND CUTTING WHEELS
Loosen and remove the screw at the top of the small screw mandrel.
Remove the top red ring from the screw and slide the cutoff wheel or
sanding disc above the bottom red ring (ensure the abrasive side of the
disc is facing up) (Fig. 2). Slide the top red ring above the cutoff wheel
or sanding disc, so that there is one red ring on each side of the wheel
or disc. Reattach the screw onto the mandrel to secure the wheel/disc
in place. Your accessory is now ready to be attached to the rotary tool
(follow the steps in "Installing the Rotary Bits" above).
INSTALLING SANDING BANDS
Loosen the screw on the top of the sanding drum using the end of the
wrench to contract the width of the drum. Slide the sanding band onto
the sanding drum (Fig. 3). Fully tighten the screw to expand the width
of the sanding drum to hold the sanding band in place. Make sure the
sanding drum is sufficiently expanded to secure the band during use.
If sanding band is loose on the drum, it may fly off during operation
and cause injuries.
INSTALLING FELT POLISHING ACCESSORIES
Thread the felt polishing accessory straight down onto the tip of the
screw mandrel (Fig. 4). The accessory must be threaded all the way
down to touch the collar of the screw mandrel.
IMPORTANT! Before operation, check to make sure that all ac-
cessories are assembled correctly and securely.
10
ASSEMBLY & ADJUSTMENTS
Small Screw Sanding Disc or
Mandrel Cut-Off Wheel
Sanding Drum Sanding Band
Felt Polishing Wheel
Screw Mandrel
Fig. 1
1
2
Fig. 2
Fig. 3
Fig. 4