Table of Contents
Advertisement
Main Menu
These screens become visible only outside of configuration mode. In this state, the REACH system is 'released' and
will become visible on the analogue addressable loop using the settings defined in configuration mode.
System Status
This menu contains options to view the current status of the REACH system. This can be used to diagnose faults.
Device Event Log
This screen contains two options:
• View Event Log
• Clear Event Log
If
VIEW EVENT LOG
is selected, the RW1700-030APO
Loop Interface LCD will display an event.
The screen layout shows the event date and time,
followed by the event number.
It then shows the details of the device that created the
event, starting with the loop address and the product
type such as 'DETECTOR'.
Finally, it will show details of what the event was. For
example 'TAMPER – ON'
See appendix 4 for a list of all log event types &
descriptions.
View Device Status
This screen can be used to scroll through connected
devices, according to their loop address and view
their status.
The initial screen is to help identify the device you
wish to view the status of. Use the arrow buttons
to scroll through the loop addresses and find the
product that you are looking for. The device Type and
Unique ID are displayed to help with this.
DD/MM-HH:MM:SS N00001
ADDR. 004
TYPE
EVENT
SELECT LOOP ADDRESS
ADDRESS: 1
NETWORK DEVICE
2H8G00BZ DEVICE: 2
PP5099/2023/Issue 1
Page 22 of 27
Advertisement
Table of Contents
