Reach PP5099 Manual page 7

Re-insert the PCB into the mounted back-box using
the two Phillips screws.
Bring the addressable loop wires in through the
cable gland and wire into the loop-in/loop-out termi-
nals as-per the wiring diagram.
Ensure that the loop is powered-off before wiring in
the product.
Note: The RW1700-030APO Loop Interface includes
a built-in bi-directional isolator (based on an Apollo
20C isolator). This automatically opens when the loop
voltage falls below a fixed threshold to prevent a loop
crash or abnormal current consumption.
The RW1700-030APO Loop Interface should power
up, showing a flashing green LED and the REACH
Wireless logo on the LCD screen. If this does not hap-
pen, re-check the installation steps.
After the RW1700-030APO Loop Interface starts-up,
it will present the First-Time-Setup wizard. See the
Commissioning instructions to continue with the sys-
tem setup. After finishing commissioning, re-install
the RW1700-030APO Loop Interface lid by re-install-
ing the four plastic screws and push-clicking the top
and bottom plastic covers back in place.
Fix the back-box to the wall using wall plugs and
round-headed Phillips screws in all of the fixing holes.
Note: Screws and wall plugs are not provided.
Ensure that multiple RW1700-030APO Loop Interface units
are installed with a minimum distance of at least 2 meters
between them.
Install with a minimum height from the floor of 2-2.5 me-
ters.
When wired into the loop and after ensuring that cables are
in the correct terminals, power the loop back on.
PP5099/2023/Issue 1
Page 7 of 27