Remove Device - Reach PP5099 Manual

Remove Device

The remove device menu can be used to 'un-pair'
devices from the RW1700-030APO Loop Interface.
To remove a device:
From the [CONFIG. MODE] menu, select
In the [DEVICE MENU], select
[SELECT LOOP ADDRESS]
ADDRESS: 2
DETECTOR
2H8G004S
The RW1700-030APO Loop Interface LCD will instruct
you to remove the batteries of the device selected,
then confirm.
Note: By default, ABORT will be selected. This is to avoid
accidental un-pairing. Use the arrow keys to select
'DONE' instead to proceed.
[REMOVE DEVICE]
DELETE DEVICE 2
YES
DEVICE MENU.
REMOVE DEVICE.
NO
[DEVICE MENU]
ADD DEVICE
MODIFY DEVICE
REMOVE DEVICE
Select the device to be removed by navigating through the
assigned device loop addresses using the up and down
arrows.
The device type and unique device ID for the device
assigned to each address will be displayed. Match these
identifiers to the physical device to be removed.
Note: The unique ID can be found on the product label.
Select the product to be replaced by pressing the enter
button.
[REPLACE DEVICE]
REMOVE DEVICE
BATTERIES
DONE
You will be asked to confirm that the device should be un-
paired.
Note: By default, NO will be selected. This is to avoid
accidental un-pairing. Use the arrow keys to select 'YES'
instead to proceed.
PP5099/2023/Issue 1
Page 18 of 27
ABORT