Table of Contents
Advertisement
Commissioning
First Time Setup
Note: the commissioning steps assume that this is the first power-on and therefore the first-time-setup wizard will
be shown. These settings are critical for a system setup. If first-time-setup does not show, all of the same settings are
available in the 'Hub Settings' menu and should be set according to the following instructions.
Note: The RW1700-030APO Loop Interface features a tamper protection spring-loaded button that will be triggered while
the front cover is not installed. This will show on the LCD display as a tamper fault during setup, as well as analogue
value of '4' on the fire panel once the system is released, until the front-cover is re-installed.
Before getting started, please ensure that:
-
RW1700-030APO Loop Interface is physically installed, connected to the wired addressable loop and
powered-on.
-
The official Apollo REACH Survey Sheet (available from Apollo-Fire.co.uk) that was used for the survey is
available, with the RF channel pair and product install locations listed.
-
All products intended to be installed are available.
Time & Date
The date and time is used for local log events.
It is important to set accurately to aid with
troubleshooting if required.
It is set in the following format:
Day / Month / Year --- Hour : Minutes
Use the arrow keys to change values
Press 'Enter' to confirm and proceed.
RF Channel Selection
This information should be already determined in the Survey Sheet that, from the survey carried out ahead of the system
installation. If this is not available or a survey has not taken place, follow the surveying steps.
REACH offers 22 RF channel pair options. Each pair
consists of a primary and secondary communication
channel, in accordance with EN54-25, with 1Mhz
separation between them.
If you are installing multiple Hubs in the same area,
select the different RF channel pairs for each Loop-
Interface to avoid communication interruptions.
RF channels should be assigned in the order that
they appeared in the background channel scan, as
per of the survey, which should be already recorded
and available in the survey sheet.
Use the arrow keys to change values
Press 'Enter' to confirm and proceed.
[FIRST TIME SETUP]
DATE & TIME
18/02/2020 10:14
[FIRST TIME SETUP]
RF CHANNEL SELECTION
1/37
PP5099/2023/Issue 1
Page 10 of 27
Advertisement
Table of Contents
