Modify Device - Reach PP5099 Manual

Modify Device

It is possible to change the settings of REACH Wireless devices that have been paired to the RW1700-030APO Loop
Interface, via the LCD display. This cannot be done via the wired fire panel as REACH is an XP95 protocol device.
The [MODIFY DEVICE] function will allow you to view device loop address, device settings (if available) and the
unique device ID (shown on the device's label).
To modify the settings of a REACH device, on the
RW1700-030APO Loop Interface:
From the [CONFIG. MODE MENU] navigate to
MENU.
[DEVICE MENU]
ADD DEVICE
MODIFY DEVICE
REMOVE DEVICE
Select the loop address of the device you wish to
view/modify.
Note: Once a device setting has been changed, you
must select SAVE & EXIT before leaving the [MODIFY
DEVICE] menu. This is located below the ABOUT menu
option.
[CONFIG.MODE MENU]
HUB SETTINGS
DEVICE MENU
EXIT
DEVICE
In the [DEVICE MENU], select
[SELECT LOOP ADDRESS]
ADDRESS:
DETECTOR
2H8G004S
PP5099/2023/Issue 1
MODIFY DEVICE.
2
Page 14 of 27