User Interface; Pcba Diagram - Reach PP5099 Manual

User Interface

The RW1700-030APO Loop Interface's embedded
user interface is used to configure the REACH instal-
lation.
The user-interface consists of:
• Arrow Keys: Up/Down/Left/Right
• Back
• Enter
USB Micro B -
Debug Port
Radio
Transmission
Module
• USB Micro B Debug Port: Used for internal debugging only
• Jumper Pins: Used for internal debugging only. Do not move or re-move these jumpers as it may cause
the Loop Interface to become partially or fully unresponsive. These should remain as shown above
• Loop-Out / Loop-In port: See Installation section for wiring diagram
• Serial Port: Reserved for future use
• Radio Transmission Modules: Used to communicate with REACH Wireless Devices
Jumper Pins
Loop-Out Loop-In
- Debug Only
PP5099/2023/Issue 1
Page 8 of 27
Serial Port
- unused
Tamper
Spring
Radio
Transmission
Module