Reach PP5099 Manual page 17

To replace a device:
From the [CONFIG. MODE] menu, select
In the [DEVICE MENU], select
[SELECT LOOP ADDRESS]
ADDRESS: 2
DETECTOR
2H8G004S
The RW1700-030APO Loop Interface LCD will instruct
you to remove the batteries of the device selected,
then confirm.
Note: By default, ABORT will be selected. This is to avoid
accidental un-pairing. Use the arrow keys to select
'DONE' instead to proceed.
REPLACE: 002
MOVE DEVICE SWITCH FROM
'ON' TO '1'
PRESS BACK TO EXIT
DEVICE MENU.
REPLACE DEVICE.
[DEVICE MENU]
ADD DEVICE
MODIFY DEVICE
REPLACE DEVICE
Select the device to be replaced by navigating through the
assigned device loop addresses using the up and down
arrows.
The device type and unique device ID for the device
assigned to each address will be displayed. Match these
identifiers to the physical device to be replaced.
Note: The unique ID can be found on the product label.
Select the product to be replaced by pressing the enter
button.
[REPLACE DEVICE]
REMOVE DEVICE
BATTERIES
DONE
The RW1700-030APO Loop Interface LCD will instruct you
to set the new device into pairing mode. Follow the same
steps as in the 'Add Device' section to successfully prepare
the new device.
Note: Once the device switch is moved on the new device, the
RW1700-030APO Loop Interface LCD should find the device
and will show multiple screens with the pairing progress. This
is essentially the same as the 'Add Device' process.
The RW1700-030APO Loop Interface LCD will inform you
of whether the replacement was successful or not. If not, it
will ask you to repeat steps.
PP5099/2023/Issue 1
Page 17 of 27
ABORT