Hub Settings; Critical Settings - Reach PP5099 Manual

The RW1700-030APO Loop Interface LCD will inform
you that the device was removed. The loop address it
occupied will be displayed here for your convenience.

Hub Settings

The Hub Settings menu is where REACH system settings are held, including critical settings that are set during
the first-time-setup process. Most settings in this menu are only required to assist in problem-solving. Most
installations will avoid the need to utilize these if they have been properly surveyed and the installation instructions
have been followed correctly. In the event that problems do occur, the Apollo technical support team are available
to assist and may recommend changing some of these settings.
Note: Before leaving the Hub settings menu, any
changes will only be saved if either:
• SAVE & EXIT is selected at the bottom of the [HUB
SETTINGS] menu
• When using the 'back' button to exit the menu, the
Hub will ask whether you wish to
is selected by default to prevent accidental changes.

Critical Settings

For instruction on these settings, view the First-Time-
Setup section at the beginning of the manual.
Settings in this menu are not applied immediately,
they are applied when leaving the menu.
Some of these settings are fundamental to the system
operation and modifying them will initiate a factory
reset whereby all settings on the RW1700-030APO
Loop Interface will be dissolved and all paired devices
will be un-paired.
SAVE or EXIT. EXIT
[REMOVE DEVICE]
DEVICE 002 DELETED
PRESS BACK TO EXIT
[HUB SETTINGS]
SETTINGS CHANGES MADE
WOULD YOU LIKE TO:
EXIT
[DATE & TIME]
RF CHANNELS
SYSTEM ID CODE
HUB LOOP ADDRESS
PP5099/2023/Issue 1
Page 19 of 27
SAVE